General Construction dredged and disposed of 62,000 cu yd of material off the Ranier Marine Docking Facility. Wharf and trestle construction included 165, 24 in. steel piles filled with 1,200 cu yd of concrete to complete the foundation. Another 1,200 cu yd of concrete was placed for the reinforced pilecaps, dolphins, bulkhead, edge beam and curb.
General Construction Company was selected to maintenance dredge the Day Island Yacht Harbor Marina. Dredging included about 6000 cy of material from the marina. We also installed new galvanized steel pipe guide piles for the new dock sections as well as new ACZA treated wood pilings as reinforcement for a nearby bulkhead.
This project required demolition of the existing Pier G float system, which consisted of 550 ft of main walk and thirty, finger piers, each 60 ft long. New construction included installation of 600 ft of 8 ft wide main walk, sixty-four 60 ft berths, a new 60 ft aluminum gangway, and cart storage area. Piledriving consisted of driving forty-four, 16 in. diameter, pipe piles. New electrical and mechanical service was also provided.
A new T-pier with 200 lin ft of fixed berthing and a 120 ft floating finger pier were built to support transient Navy vessels and small crafts. The facility also includes a floating boathouse, to provide covered moorage for the Admiral's barge, and three smaller slips. Mechanical and electrical utilities were provided for all new structures along with relocation and installation of existing jib cranes and other vessel service equipment. Demolition of two existing timber piers and the existing fixed boathouse were included as part of the project scope.
General Construction Company partnered with BERGER/ABAM for this Design/Build project. The contract required demolition of an existing 650 ft timber pier and construction of a new replacement concrete pier and concrete mooring floats. The construction included 16 in. diameter concrete piles, poured in place caps, precast deck panels, and crane beams. In addition to the new pier, a custom 25-ton capacity 'Marine Travelift' boat hoist was installed.
The new Benicia-Martinez Bridge is a four frame, 2,266 meter long by 25 meter wide cast-in-place, post tensioned, segmental concrete bridge spanning the Carquinez Strait. The superstructure is supported by seventeen pile-supported foundations, twelve of which are located in water. The bridge carries five lanes of northbound Interstate 680 traffic and has the potential for a future BART light rail lane.
The E2 foundation, on the east end of the project, consists of a composite steel and concrete footing founded on 16 cast-in-steel shell piles driven 300 ft into the San Francisco Bay mud. The T1 foundation at the west end of the project is the foundation for the main suspension tower of the self anchored suspension bridge. It consists of 13 cast-in-place drilled hole piles which extend approximately 200 ft into the Alameda rock formation.
GCC is a subsidiary of Kiewit Corporation. This link will direct you to Kiewitjobs.com where you’ll find a comprehensive list of all Kiewit and subsidiary staff opportunities. If you would like to view GCC jobs only, use the search tool to narrow results.
33455 6th Avenue South
Federal Way, WA 98003
Tel: (253) 943-4200
Fax: (253) 943-4021